| Kyoritsu Power Quality Meter KEW6310-11
Clamp Sensors: 8129-03 x 1
Can measure Flicker in accordance to IEC 61000-4-15 and EN50160 standards. Using our Flicker sensor, available as optional accessory, Pst value (short term severity in 10 minutes value) and the Plt value (long term severity in 2 hours value) can be measured.
12 kinds of Power Measurements for Power Control and Applicable to Power Quality Control including Harmonics Analysis.
One click easy-to-use operation helps complicated setting and processing of large data through the setting / analyzing software provided as accessory.
Direct communication with PC via USB cable
Built-in Input / Output Function of external signal enables the signal transmission to alarms.
2-way power supply by AC and Battery, and Nickel hydrogen battery usable with rechargeable function.
Pull / Insert of CF card possible whenever on recording under the function of memory backup device.
Can monitor insulation at leakage current by using optional leak clamp sensors.
Built-in Print Screen Function enables to record display screen
(Records 512 screens by using CF card: 1 screen 40KB).
Can display Waveform and Vector, and can confirm the wiring connection, too.
Complies fully with International Safety Standards IEC 61010-1 CAT.III 600V.
|
* Attention for KEW6310 customers: |
|
|
|
Flicker measurements are possible with firmware of KEW6310 upgrade (Ver.2.01), PC software PQA Master upgrade (Ver. 2.01) and an optional accessory Flicker sensor KEW8325F. |
| Wiring connections |
 |
|
|
1P 2W, 1P 3W, 3P 3W, 3P 4W |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Measurements and parameters |
|
|
|
Voltage, Current, Frequency, Active power, Reactive power,
Apparent power, Active energy, Reactive energy, Apparent energy,
Power factor (cos θ), Neutral current, Demand, Harmonics,
Quality (Swell/Dip/Instantaneous Stop, Transients/Over Voltage, Inrush Current, Unbalance Rate, IEC Flicker [Pst(1 min)*, Pst, Plt]), Phase Advance Condenser
(*Pst can be shown in details for 1 minute intervals.) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Other functions |
|
|
|
Digital output function, External communication function,
Scaling function |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Voltage : |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Ranges [RMS] |
|
|
|
150 / 300 / 600 /1000V (CF: 2.5 or less, 100% or less of each range) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Allowable input |
|
|
|
10~110% of each range (1000V range : 20%~) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Display ranges |
|
|
|
5~120% of each range |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Accuracy |
|
|
|
|0.3%rdg0.2%f.s. (sine wave, 45~65Hz) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Current : |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Ranges [RMS] |
|
|
|
| 8128 ( |
50A |
type ) |
: |
1 / 5 / 10 / 20 / 50A |
| 8127 ( |
100A |
type ) |
: |
10 / 20 / 50 / 100A |
| 8126 ( |
200A |
type ) |
: |
20 / 50 / 100 / 200A |
| 8125 ( |
500A |
type ) |
: |
50 / 100 / 200 / 500A |
| 8124 ( |
1000A |
type ) |
: |
100 / 200 / 500 / 1000A |
| 8129 ( |
3000A |
type ) |
: |
300 / 1000 / 3000A |
| (CF:3.0 or less. 90% or less of each range) | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Allowable input |
|
|
|
10~110% of each range |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Display ranges |
|
|
|
1~120% of each range |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Accuracy |
|
|
|
|0.3%rdg0.2%f.s. + Accuracy of Clamp sensor
(sine wave, 45~65Hz) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Activa power accuracy |
|
|
|
|0.3%rdg0.2%f.s. + Accuracy of Clamp sensor
(Power factor 1, Sine wave, 45~65Hz) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Influence of power factor |
|
|
|
|1.0%rdg (reading at power factor 0.5 against power factor 1) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Frequency meter range |
|
|
|
40~70Hz |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Internal memory |
|
|
|
| 1.8MB |
|
|
| Measurement file (CSV) |
: |
256kB6 blocks (=1.536MB) |
| Screen file (BMP) |
: |
32kB7 blocks (=0.224MB) |
| Configuration file (KAS) |
: |
32kB | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Display |
|
|
|
320240 (RGB) Pixel, 3.5-inch color STN display |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Temperature & humidity range |
|
|
|
23C5C, Relative humidity 85% or less (no condensation) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Storage Temperature & humidity range |
|
|
|
-20C60C, Relative humidity 85% or less(no condensation) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Operating Temperature & humidity range |
|
|
|
0C40C, Relative humidity 85% or less(no condensation) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PC Card type *1 |
|
|
|
Compact flash card
(Capacity: 32 / 64 / 128 / 256 / 512MB / 1 / 2 / 4 / 8GB)
| * |
The CF card larger than 2GB is usable, however, the possible stored size will be limited to 2GB. For example, when the CF card of 4GB or 8GB is used, the maximum stored size will be 2GB. | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Applicable standards |
|
|
|
IEC 61010-1 CAT.III 600V Pollution degree 2
IEC 61010-031, IEC 61326 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Power supply |
|
|
|
AC 100V ~ 240V10% (45~65Hz)
Alkaline size AA battery LR6 (9V 1.5V 6) or Ni-MH (HR15-51) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Dimension |
|
|
|
175(L)120(W)68(D) mm |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Weight |
|
|
|
approx. 900g (including batteries) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Accessories |
|
|
|
7141A (Voltage test lead)
7148 (USB cable)
7170 (Power cord)
9125 (Carrying case)
8307 (Compact flash card 128MB)
8319 (CF Card reader)
Input terminal plate (6-kind)
Alkaline size AA battery (LR6) 6
PQA MASTER (PC Software)
Quick manual
Cable marker 32 |
|
All prices are in Canadian Currency