ULTRAPROBE 100 Ultrasonic Inspection System
Includes UP100 pistol housing with LED bar graph meter, 8 position sensitivity selection, low battery indicator, scanning module, rubber focusing probe, stethoscope module warble tone generator (WTG-1) with battery charger, deluxe noise isolating headset, 9 volt alkaline battery, HDPE plastic carrying case and comprehensive instruction manual.
Pressure & Vacuum Leak Detection
Valve Seat Leak Detection
Exhaust System Leaks
Steam Trap Inspection
Gear/Gear Box Inspection
General Mechanical Inspection & Trouble Shooting
Tank/Pipe Leak Testing
Construction: Handheld ABS pistol type ultrasonic processor, stainless steel sensor enclosures
Circuitry: SMD/Solid State hybrid heterodyne receiver
Frequency Response: 20-100 kHz (centered at 38-42 kHz)
Indicator: 10 segment LED bargraph (red)
Sensitivity Selection: 8 position precision attenuation
Power: 9 Volt Alkaline Battery
Low Battery Voltage Indicator: LED
Headset: Noise isolating type: double headset wired monophonic impedance; 16 ohms. Over 23 dB noise attenuation. Meets or exceeds ANSI specification and OSHA standards.
Scanning Module (SCM-1) Stainless Steel Unisonic (single transducer) piezo electric crystal type; Stethoscope/Contact Module (STM-1) Stainless Steel plug-in type with 5.5" Stainless Steel Waveguide.
Rubber Focusing Probe: Shields stray ultrasonic signals & focuses detected signals.
Transmitter: Patented warble tone transmission
Response Time: 300 m. sec.
Ambient Operating Temperature Range: 32°-120°F(0°-50°C)
Relative Humidity: 10-95% non condensing at up to 86°F(30°C)
Storage Temperature: 0°-130°F (-18°-54°C)
Warranty: One year, parts/labor. (Details available on request)
Dimensions: 5.25" x 2" x 8" (13.3cm x 5cm x 20.3cm)
Weight: 11 oz (.3kg)
Carrying Case: Nylon soft carry case with die cut foam
*In an effort to provide the highest quality, specifications are subject to change without notice